Elation 1400E Instrukcja Użytkownika Pobierz pdf (Strona 32)

Run Hyper Terminal by clicking on “Start” in Windows then “Programs” then “Accessories” then “Hyper

Terminal”. If for some reason Hyper Terminal is not installed on your version of Windows, install it from

your Windows CD. Go to the control panel, select Add/Remove Programs, select Windows Setup, and

then select communications. Follow the instructions.

Once the Hyper Terminal folder is open, double click on “Hypertrm.exe” or “Hypertrm” which will start

the Hyper Terminal program. You will be asked to choose a name and an icon. Name it Show Designer

then pick any icon then click on OK. Go to the bottom of the next dialog box and choose “connect to”

“Direct to COM 2”. Ignore the telephone number and other settings in this box then click OK. In the next

dialog box, set bits per second to 19200, data bits to 8, parity to none, stop bits to 1, flow control to none,

then click OK. You will now be running Hyper Terminal. One last item needs to be set by clicking on

“File” in the upper left corner of the window, then “Properties”, then select the “settings” tab. From the

settings tab click on the box that says “ASCII Setup”. From that dialog box make sure the box labeled

“send line ends with line feeds” is checked, you can also leave the box labeled “wrap lines” checked but

leave all of the other boxes unchecked. Click OK and you are done with setup. Close Hyper Terminal and

you will be prompted to save this Hyper Terminal setup. Click yes to save it and you will return to the

Hyper Terminal folder. There should now be a program in the folder labeled “Show Designer.ht” or

“Show Designer”. You may want to make a shortcut on your desktop if you plan to use your PC with

Show Designer 2 often. From this point on, whenever you communicate with Show Designer 2 using your

PC, call this Show Designer Hyper Terminal configuration.

MEMORY BACKUP USING THE COMPUTER PORT

Once configured, you can use SD Backup or Hyper Terminal to back up the Show Designer 2 memory

using your PC. Connect the Show Designer 2 to your PC as described in the previous paragraphs.

If you are using the SD Backup program, follow the instructions for “Receive File”. To use Hyper

Terminal, call the version of Hyper Terminal that you created for Show Designer 2. Click on “Transfer” on

the top menu bar and select “Capture Text”. A dialog box will appear allowing you to select a folder and

name for the backup file. Use a name like “SD2 backup1.txt”. Click “Start” and Hyper Terminal is now

ready to receive the file from Show Designer 2.

Next, go to the menu selection on the Show Designer 2 labeled “save memory file to COM port” and press

the “enter” switch. The display will read, “Press enter to send memory file”. Press “enter” to start the

transmission from Show Designer 2. An encoded copy of the entire memory will be transmitted to your

PC. If you are using Hyper Terminal, a series of numbers will be displayed in the Hyper Terminal window

as the file is being copied to your disk drive. The time needed to send the memory file will vary depending

on the amount of memory currently in use. When the file is finished being sent, Show Designer 2 will

return to its startup display and the numbers will stop scrolling in the Hyper Terminal window. You can

either close Hyper Terminal or return to the “capture text” pull down menu and select “stop”, the file will

automatically be saved.

Note: When creating additional memory backup files using Hyper Terminal, always start with a new text

file. Hyper Terminal will not write over an old file that has data in it but will add the new data to the file

giving you multiple memory dumps in one file.

1 2 ... 27 28 29 30 31 32 33 34

Brak uwag

Elation 1400E Instrukcja Użytkownika Strona 32