Elation 1400E Instrukcja Użytkownika Pobierz pdf (Strona 8)

setting for channels that control functions like pan and tilt or dimming to achieve a smooth transition from

scene to scene. If you use this setting for gobo or color wheel channels, this will cause the wheels to step

through all positions between the start and end positions of a long fade. This is usually the default setting

for pan, tilt and dimmer channels.

“Snap before fade” will cause the channel to jump immediately to the next scene level as soon as the new

scene is called. Use this setting for channels that control motor speed so that pan and tilt will move at the

correct speed during the fade. You can also use this setting for wheel channels that you want to change at

the start of long crossfades. This is usually the default setting for speed and mode channels.

“Snap after fade” will cause the channel to jump immediately to the next scene level at the end of a

crossfade. Use this setting for wheels and effects that you want to take effect after a long crossfade is

complete. This is usually the default setting for color and effects wheels.

COPY FIXTURE

This is used to copy the fixture type and attributes from one fixture number to another. When setting up a

group of fixtures that are all the same type, this feature saves time by letting you copy the fixture choice

rather than searching through the list for each fixture. Use the + and - switches or data wheels #1 and #2

to select a fixture number to copy from and to. You must press “enter” to complete the copy process. If

auto patch is enabled you will be given the warning that some addresses may change. Press “yes” to

continue or “no” to exit. If a fixture is already set up at the “copy to” location, you will be asked if you

want to copy over the existing fixture, press “yes” to copy over it or “no” to exit.

PAN AND TILT INVERT

The joystick can be used to control pan and tilt if a fixture has a pan and tilt feature. Sometimes a fixture is

oriented in a way so that its pan or tilt movement is opposite that of the joystick movement. You can use

this to invert the direction of the pan or tilt for each fixture. This setting will not affect the faders or the

wheels when they are used to control pan or tilt. With this menu displayed, use the + and - switches or data

wheel #1 to select the fixture then use data wheels #2 or #3 to set the invert states for pan or for tilt. You

must then press, “enter” to save the selection.

ADJUST FACTORY CHASES

Show Designer 2 provides 48 preprogrammed chases of pan and tilt movements that are referred to as

factory chases. These are mostly circle movements and some other pan and tilt effects. This menu allows

you to adjust the pan and tilt centers of these chases. This feature is helpful when one of the circle chases is

close to what you want but is not pointing in the exact desired location. Use this while the chase is running

so that you can see the results. First select the factory chase number (1-48) using data wheel #1 then adjust

the pan or tilt offset using data wheels #2 or #3. The offset can be adjusted in a plus or minus direction.

This menu does not require you to press “enter” to complete the change. Be aware that any scene that uses

this factory chase will be affected by this adjustment.

SELECT HOME SCENE

This allows you to select a home scene that will be called automatically whenever you use the “clear all”

function by holding down the “black” switch for 2 seconds. This can be used to call up a default lighting

configuration such as all beams centered, full intensity at white when building a new scene. Use the menu

switches or data wheels 1 and 2 to select the desired page and scene number then press “enter”. You must

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Brak uwag

Elation 1400E Instrukcja Użytkownika Strona 8